Quantcast
Channel: Heavy Equipment Forums - Track Loaders
Browsing all 1194 articles
Browse latest View live
↧

Cat 931b rear transmission seal

Hey Guys, I have a 1986 931b serial # 29Y1 3f/3r with a fluid leak at the rear transmission seal at the drive shaft. Is it possible to replace this seal in the machine? Seems like I heard somewhere it...

View Article


Image may be NSFW.
Clik here to view.

CAT 955L Front Idler bushing Replacement?

On Saturday I was looking at the front idler on the old 955L and noticed the idler wasn't aligned in the yoke. In fact the track pads seem to be turning out away from the engine. I then grab a pry bar...

View Article


Cat 955l for sale

Beautiful CAT 955L For Sale on Ebay. Link: http://www.ebay.com/itm/181648912431...%3AMEBIDX%3AIT

View Article

1996 963b track loader blew trans hose replaced and not have no bucket...

I had a hose wear and leak it was the transmision I assume as when I noticed the leak the Hydrostatic oil was low. on the drivers side below the floor there is a bell housing that the HS filters are...

View Article

955l bottom questions

could somebody tell me the whats the difference between a 955l big bottom and a 955l small bottom ?

View Article


850 B retro fit

I also posted this in the Dozer section since the 850 came in both configurations. I own a Case 850 B TL with the 336 turbo. It died and spun a bearing and ruined the block. To rebuild myself will cost...

View Article

955l spec,s.

JUST A FYI FOR YOU 955 GUYS. http://www.ritchiewiki.com/wiki/inde...Crawler_Loader

View Article

Called heavyquip today

Well i,ve found a few 13x cat 955l loaders. started looking for some referb parts. mahale/clevite in frame rebuild kit is about 1400.00, dont know how this compares to genuine cat, a new radiator and...

View Article


Repacking 955k cylinder

I was just wondering what is the average price to have someone repack a bucket tilt cylinder on a 955k. I'm here in missouri and would just like an idea on a price before I start calling around so I...

View Article


125c moves erratically in forward

One time it will push over a 14"oak with a single pass and the next minuite it will barely move forward. Cannot believe its clutches if it has that kind of power sometimes. Reverse seems to be normal...

View Article

B model cat loader steering

I'm starting to think I'm imagining things. I've looked at so many hundreds of machines in my life I can't remember everything the clearest. I keep thinking that about 10 or 12 years ago I looked at I...

View Article

I found a 941 cat 1 mile down the road !!!

Well all the honey suckles have died down for the winter and i was driving down the road and seen a piece of yellow sticking out. found out its a 941. i dont think its a "b" model as it doesnt have any...

View Article

JD 555G Transmission Pressure Light

I have an early (1989) JD 555G with warning lights on the dash. I believe that the same light is used for the transmission temp and for the trans low pressure. Can someone tell me if the pressure...

View Article


973

Hi everyone my 973 has been getting very slow with the bucket functions up and it will not tilt the bucket up now well serviced oil and filters regulary where can I check pressures thanks.

View Article

Case 1150b low range track clutch.

I have an 1150b loader. The right track will not work in low range. Everything else works including the brakes. When I pull the the lever it feels different. Kinda spongy. I've checked the linkage. The...

View Article


International 250C

http://louisville.craigslist.org/hvo/4893854608.html Found this jewel today. I don't know much about these but it looks like a good size machine. I think most people have 175?

View Article

Kamotsu 31S

I am looking at a Kamotsu 31S track Loader, with a GP bucket. It is a one owner that was used on a farm. The machine was lightly used, and very clean, tight machine, with very nice original paint. UC...

View Article


1975 case 450 engine problem

hi guys, sorry for my bad english here we mostly speek french so .... here is the deal i found a case 450 1975 on kijji the onwer say it have engin problem he just want to get rid of it so i didint...

View Article

What to look at on a used Cat 963

Probably going to look at a 1988 Cat 963. Price is right but it has 22k hours. Would be used mostly for fixing up farm fields and maybe cleaning out a few trees. What should I specifically look at and...

View Article

Cat 955 K Steering Clutch

I've got a 955 K, 85J serial prefix. The clutches on the left side went out, and the brakes are pretty thin also. I've got a mannual, and parts mannual, but it doesn't specify how many plates, steels...

View Article
Browsing all 1194 articles
Browse latest View live